Number of amplifier channels: 4
Peak total output all channels driven: 10000 W
Peak output voltage per channel:
150 V
Max output current per channel:
50 A
peak
Max output power (all channels driven):
2 ohms
2500 W
4 ohms
2100 W
8 ohms
1300 W
16 ohms
660 W
Max output power bridged:
4 ohms
5000 W
8 ohms
4200 W
16 ohms
2600 W
Performance
THD 20 Hz - 20 kHz at 1 W:
<0.1%
/ THD at 1 kHz and 1 dB below clipping
<0.05%
Signal to Noise Ratio:
>112 dBA
Channel separation (Crosstalk) at 1 kHz:
>70 dB
Input impedance:
20 kOhm
Common Mode Rejection (CMR):
>54 dB, 20 Hz - 20 kHz
Gain, Sensitivity and Limiters
VPL selectable per ch:
150, 121, 101, 83, 70, 56, 47, 38 V
VPL when bridged:
300, 242, 202, 166, 140, 112, 94, 76 V
Voltage Peak Limiter mode (per ch.):
Hard / Soft
Amplifier gain selectable (all channels) – rear-panel switches: 23, 26, 29, 32, 35, 38, 41, 44 dB
Default gain:
35 dB
Output connectors (per ch.):
Neutrik speakON
Input connectors (per ch.):
3-pin XLR,
Output: bridge mode
A+B - Ch. A is signal input source. A+B, C+D - Ch.’s
A and C are input source
NomadLink network
On board, 2 x RJ45 connectors IN and OUT
Intelligent fans, depending on presence of output signal
Power on/off and Remote enable on/off
Individual switches on front-panel
Cooling
Dual fan, front to rear airflow, no filter required, temperature controlled speed
Front-panel user interface
Common
NomadLink Network; Power Average Limiter (PAL)4;
Power on
Per channel
Signal present / High-impedance; -10 dB and -4 dB
Output signal; Voltage Peak Limiter (VPL); Current Peak Limiter (CPL): Very High Frequency (VHF); High temperature; Fault; Mute
Power
Operating voltage, 230 V / 115 V nominal 3
130-265 V / 65 -135 V
Minimum power-up voltage, 230 V / 115 V
171 V / 85 V
Power
Average Limiter (PAL): 4x
Soft-start / Inrush Current Draw: max. 5 A
Mains connector
230 V CE: 16 A, CEE7; 115 V ETL: 30 A Twist lock
Dimensions: 2 U
